Aprilia RS125 Full power Rotrax 123 Spares or Repair

Sold as a non runner

no tax or mot

The engine has been fully refurbished alongside the entire bike with only the best parts used from pjme 2t specialists. The bike has done 300khm since the rebuild then decided to cut out at a junction and would not start again. This turned out to be a wiring issue. A NEW LOOM IS NEEDED.

Koyo race bearings for the entire bottom end + oil seals

Mitika 54mm piston kit + titanium coated rings

Full athena gasket kit + o-rings

34mm carb kit

clutch + brake levers

speedo cable

balance shaft gears + tacho / rev counter drive gears

yuasa 12v battery

New spark plug

Fuel filters (Not fitted)

New fuel tap (Not Fitted)

indicators

Starter motor

Full arrow exhaust system + hangers

Being the rotax 123 engine with no restrictions at all it already came standard with the 34mm carb and the power valve / solenoid. but all have been checked and the valve stem seal replaced for the power blade etc.

The bike currently has all the fairings off and the carb removed so I could get to work on the wiring loom. I've since been mega busy with work an unable to carry on. My plan was to order a new loom and have it up in a few days. But with my current job I travel up & down the country for long periods of time. I would have loved to carry on but it's just not do-able at this time.

The bike is in superb condition for its age and is becoming very rare and collectable.

Uk bidders only with 10 feedback minimum or the bid will be removed

Cash on collection

Being a non-runner this will need to be collected by a van/trailer.  

Also published at eBay.com