Chopper Rolling Chassis Kit w/ 280 Rear End

Increase traffic to your listing with Auctiva's FREE Scrolling Gallery.This listing is for a 6up-4out 280mm rear Chopper Chassis Kit with MANY extras! The Frame is a Santee single down tube wide tire version that will run a 250mm to 280mm depending on set up. I have it stuffed with a 280 and ISR 48tooth Sprocket brake. The tollerances are VERY tight this way and give it a very radical look. Wheels are DNA 80-spoke rear with chrome billet spooled hub and stainless spokes, nd 40 spoke front to match. The fenders are cut from heavy gauge spun blanks. The mounts are done and welded for the 280. The drive is aligned and requires a 2.5" offset with .5" in the motor and another 2.000" in the Trans Plate and Motor Spacer. The gas tank was hand pounded out of aluminum keeled 18-gauge steel and tacked for pre-mock. The tunnel and bottom is formed and ready to weld along with included mounts(As shown in pictures). The handlebars are a one-off design that I co-created with Gard Hollinger of LACC while working at his Fab shop during the famed Discovery and Speed Channel era in the mid 2000's. I haven't seen a set of drag bars like this before or since. The triple trees are 5 degree L.A. Choprods in raw billet. Oil tank mounts set up for Moon Eyes(tank not included)
The Kit I am offering here comes as shown in pictures with many extras to help you along with the build. Here's what you get....
-Rolling Chassis Complete as shown in pix with MSO (Gutted Longblock and oil filter housing NOT included)
-Fenders (as shown in pix)
-One-Off hand pounded gas tank with filler bung and Knockoff cap
-Primary Drive Housing (inner and outer-no guts)
-Oil tank mounting rings(oil tank NOT included)
-48-tooth Sprocket /brake hangar (Caliper NOT included)
-Rear axel/ covers
-Showa Lower Legs
-Performance Machine foot controls(all linkage and mounts must be fabricated by builder)
!!!!!PLEASE NOTE !!!!! As stated above, he Motor and L.A. Choprods oil filter housing shown in pictures is NOT included in this listing. They are installed in this pre-mock for purpose of visual affect and installation of related components.
Thanks for looking and please don't hesitate to contact me with any questions you may have. HAPPY BIDDING!! -CHOPMAN

Also published at eBay.com