Custom Chopper, Bobber, Ground up Build, Buy it for far less than the parts cost

This Custom Built Chopper/Bobber was built for someone with the desire for a Motorcycle that has the old school look but also comes with the some of the new school feel. The parts in this build cost way more than what we expect to sell it for and our labor hours were never calculated in because we knew from the start that we would not be able to recover those. Here is a quick run down of what was used and I will try to be as thorough as possible. 24 Coats of House of Kolor Paint including Metaljuls for the basecoat. Pagan Candy for the top coat and of course lots of Metallic Flake sprinkled in for that sparkle in Sunlight. The frame is a Paughco with some minor modifications for the Footcontrols and Oil Bag. 80" EVO Harley Davidson MotorAuthentic Paughco Springer front end. Performance Machine 4 Piston front brake. Exile Sproter Rear Brake. Avon 200 rear Tire. Chain Drive with Autotensioner welded to frame. Bobber Seat Custom Handtooled Leather from Nomad. Rear Sissybar heat twisted and fabicated in our shop. It is welded to the frame. Rear Fender shaped in our shop on our English Wheel and welded and molded to the frame. No visible weld marks. beautifully done. Custom Oilbag with the HB insignia. 21" front Rim and a 18x200 RearCarlini drag barsClosed Wet Clutch Primary6 Speed Transmission-TrickshiftThunderheart Wiring harness with a Micro Controller. Custom FootcontrolsThis Chopper comes with a MCO from HellBilly Motorcycles which has a Manufacturers License. this will provide you with necessary paperwork to get a Title from you DMV and "NOT" ONE OF THOSE SPECIAL CONSTRUCTION TITLES"Yes this bike fires right up but has not been test ridden. it needs to have some adjustments made to the footcontrols which currently have Pegs that are too long for tight cornering. It also needs a small bracket modification made to the front brake bracket which can be easily attained thru Performance Machine. Lastly. the Gas tank should be moved back about 1" to provide adequate travel of the forks. We would gladly rectify the above mentioned items however at this rock bottom price we would would require and additional $1000 for labor and parts.

Also published at eBay.com