Assembled Harley Custom Softail Springer Ultima 127" Baker 6 speed

Put that tax return to good use on this custom assembled bike. It's been in storage for the last 4 years. I took it out for a 20 mile ride last fall and everything ran fine. The Ultima 127” engine with a custom dual Ultima R1 carb’s is matted to a Baker “Torque Box”transmission, ”BDL Primary to a 530 Chain final drive with a Russell Mitchell “Sprotter” brake setup. The front end is a Pauco 4” over Springer front end with a Wind Vest fairing. Handle bar controls are Arlen Ness with Bad Lands Mirrors. These are the mirrors that have the gages in them. The chine spoiler is also a 3.5 quart oil tank. I’ve never seen the temperature above 220° The Exhaust is Thunderheader that I added an O2 sensor to. The readout is under 1 of the speaker covers on the dash. The other speaker cover is blank. (no speakers either – I was going to add them, ut the bikewas much fun) It has the Legends air ride setup on the Pro-one 4 link rear end. The transmission utilizes the Baker built-in ignition kill switch for FULL-THROTTLE shifting by foot or Jockey without using the clutch or letting off the throttle. The Rat Fink even lights up. There are (2) 300cca batteries under the seat to roll the motor over using the 2.4KW starter. I’ve dyno’d it at over 120 HP to the rear wheel and have run a 10.7 sec ? mile on the Teressi Dyno Drags. J Comes with lots of paperwork. Please note that there are some paint defects and chips (see pictures). I have around 7000 miles on the paint. I’m sure I have missed some things so any questions please email me or call 517-250-5905.

Also published at eBay.com