Custom Harley Davidson Ironhead Chopper -- NO RESERVE!!!

Head turning Custom Built Paughco Rigid frame chopper with 1974 HD 1000cc Ironhead Sporty Engine. Super low with a 4 inch ground clearance and a Springer Front End.

Tranny: HD 4 speed (shift on right side)

S&S Super E Carb

CC Rider Electronic Ignition

Dynatek Coil

Electric Start with Key

2 1/4" Frame Stretch with 38 Degrees Rake

Front Disc Brake

Rear Drum Brake

Drag Handle Bars with 6" Riser

Chopper World Solo 5" Spring Seat

Forward Controls

Revtec Nickel O-Ring Chain

Drag Pipes

Tons of Chrome

Needs a new home, just don't ride it anymore. Great to take to bike shows or rally's -- gets tons of attention. Front tire could stand to be replaced and brakes could be updated or upgraded if any serious riding is going to be done. Needs a good bath and detail and its ready to go to the show. Fresh oil change with 0 miles since changing. Just put a new starter and solenoid on it as well.

This bike isn't for everyone...If you are not familiar with a Rigid frame and an old HD Ironhead, hen you might want to do a little research before considering buying this as a bike to ride. Also, his isn't a bike that your going to ride over the mountains and across the plains to granny's house...its a BareBones-BarelyLegal-BarHopper Special, ot a touring bike -- fun for short jaunts from local place to place then back home to rest.

Please ask any questions you might have and I will try to answer them. Serious bidders only -- don't bid if you can't pay for it or don't intend to.

Sold as is where is -- Elkhart, N

I prefer pickup in Elkhart, N -- But will build a heavy wood shipping frame/crate for $200 if the winner needs it shipped (I have a truck shipping dock that it can be loaded from). ALL shipping costs and arrangements are buyers responsibility.

$250 Non-Refundable deposit due immediately at auction end to secure sale, nd balance (CASH ONLY) due at pickup or prior to shipping.

Good Luck!

Also published at eBay.com